Monica Reed

Photo: Canva

Will Clarksville & Hopkinsville see a total or partial eclipse and can you wear a welding helmet?

Remember in 2017 when it went dark for a few minutes because of the total solar eclipse that came through Clarksville and Hopkinsville? Could it happen again?

The total solar eclipse in 2024 is expected to occur on April 8, 2024. The eclipse will take place during the daytime, and the timing of the event will vary depending on your location. It is important to note that the path of totality, where the Sun will be completely covered by the Moon. The total solar eclipse in 2024 will be visible across parts of North America. The path of totality will span from the southwestern United States to the northeastern United States and eastern Canada. It will start in Mexico and move across states such as Texas, Arkansas, Missouri, Illinois, Kentucky, Indiana, Ohio, New York, Vermont, New Hampshire, and Maine, as well as the Canadian provinces of Ontario, Quebec, New Brunswick, Prince Edward Island, and Newfoundland. The duration of totality will vary along the path, with the maximum duration occurring near the point of greatest eclipse.

But will we see it here???

Yes, we will experience a partial solar eclipse during the total solar eclipse event on April 8, 2024. While Clarksville is not in the path of totality, it will still witness a partial eclipse where a portion of the Sun will be covered by the Moon. To see the total solar eclipse in its entirety, you would need to travel to a location within the path of totality.

(Video courtesy of Lost in the Pond)

Remember to have your solar eclipse glasses or maybe a welding helmet??  Can you use a welding helmet??

Yes, you can use a welding helmet with the appropriate shade for viewing a solar eclipse. It’s important to use a welding helmet with a special-purpose solar filter or “shade” that is designed for solar viewing. Regular welding helmets typically have filters that are too dark for safely viewing the Sun during an eclipse.

The recommended minimum for solar viewing is a welding helmet with a shade of 14, but some sources suggest that a slightly lower shade, such as 12 or 13, may also be acceptable. It’s crucial to ensure that the welding helmet meets the necessary safety standards for solar viewing.

Additionally, if you’re using other methods to observe the eclipse, such as solar viewing glasses or solar viewers, make sure they are specifically designed for safe solar observation. Never use regular sunglasses or improvised filters, as they don’t provide sufficient protection for direct viewing of the Sun and can cause serious eye damage.

(Video courtesy of Kentucky Educational Television)

News from ClarksvilleNow.com

The suspect in the bank robbery at Walmart on Madison Street on Oct. 21, 2025. (Clarksville Police Department, contributed)

yesterday in Crime, News

UPDATE: Bank robbery inside Walmart on Madison Street in Clarksville

The bank inside the Walmart on Madison Street in Clarksville was robbed Tuesday afternoon, and police were searching the area for the suspect.

yesterday in News

UPDATE: Power restored after outages affecting traffic signals downtown

A power outage is affecting over 500 residences in downtown Clarksville and some traffic signals.

yesterday in News

Montgomery County Commission debates support for public notice in newspapers

The County Commission’s 2026 legislative agenda seeks to “remove the burden” of local governments having to publish public notices in newspapers.

yesterday in News

Gary the Guardrail lives on in final resting place at O’Connor’s Pub in Clarksville | PHOTOS

Gary the Guardrail has been memorialized at O’Connor’s Pub at the intersection of Trenton and Tylertown Roads in Clarksville.

Erin Poland Nolder (Contributed)

yesterday in Elections, News

Erin Poland Nolder announces candidacy for General Sessions judge

Local attorney Erin Poland Nolder has announced her intentions to run for General Sessions judge in Montgomery County.